Installation guide

31
Enhancements
Release Y.11.16 Enhancements
■ Stop-Only: Applies to the network, exec, system, and command service types, as described
below:
• Send a stop record accounting notice at the end of the accounting session. The notice
includes the latest data the switch has collected for the requested accounting type (network,
exec, or system service types). For the commands service type, sends the “Stop” accounting
notice after execution of each CLI command.
• Do not wait for an acknowledgment.
■ Interim-Update: Applies only to the command service type, and is intended for use when
the optional common session ID is configured. Enabling interim-update in this case results in
the command accounting records appearing as enclosed sub-parts of the exec service type
record for a given management session. (Using interim-update when the unique session ID
is configured has no effect because in this case, the different service types appear as separate
accounting processes with separate Acct-Session-ID values.
Note
Configuring interim-update for Command accounting results in all commands being reported as
“update” records, regardless of whether common or unique is configured for the accounting session
ID (page 29).
Syntax: [no] aaa accounting < exec | network | system > < start-stop | stop-only >
radius
[no] aaa accounting command < stop-only | interim-only > radius
Configures RADIUS accounting service type and how data will be
sent to the RADIUS server.
< exec | network | system | command >: Specifies an accounting
service type to configure. Refer to “Accounting Service
Types” on page 30.
start-stop: Applies to exec, network, and system
accounting service types. Refer to “Accounting
Controls” on page 30.
stop-only: Applies to all accounting service types.
Refer to “Accounting Controls” on page 30.
interim-update:
Applies to the commands accounting
service type. Refer to “Accounting Controls” on page
30