System information

9-44
Configuring Advanced Features
HP ProCurve Stack Management
Configuring Advanced
Features
Syntax: [no] stack member <switch-num> mac-address <mac-addr>
Use show stack view to list the stack Members. For example, suppose that you
wanted to use the Commander to remove the “North Sea” Member from the
following stack:
Figure 9-34. Example of a Commander and Three Switches in a Stack
You would then execute this command to remove the “North Sea” switch from
the stack:
HP2512(config)# no stack member 3 mac-address 0030c1-7fc700
where:
• 3 is the “North Sea” Member’s switch number (SN)
• 0030c1-7fc700 is the “North Sea” Member’s MAC address
Using the Member’s CLI To Remove the Member from a Stack.
Syntax: no stack join <mac-addr>
To use this method, you need the Commander’s MAC address, which is
available using the show stack command in the Member’s CLI. For example:
Figure 9-35. Example of How To Identify the Commander’s MAC Address from a
Member Switch
Remove this Member
from the stack.
MAC Address of the
Commander for the
Stack to Which
the“North Sea”
Switch Belongs
CLI for “North Sea”
Stack Member