ProCore Instructions

Side Joints: For the following rows, insert the long side tongue of the flooring into the previously installed plank groove at an angle
of about 25°, ensure the joint is seated properly, slide the flooring towards the previous end joint (or spacer) until perfectly aligned.
While pressing into the long side, lower the flooring into position. Complete the end joint, as before and continue with the installation.
During the installation, and only if required, use an ~ 6-inch scrap piece of flooring locked into the joint (not a tapping block) and
lightly tap together any minor gaps with your mallet to properly connect the locking mechanism. After the first five or six rows are
completed, turn yourself around and continue installing, working from the installed flooring. The benefit is you are now “pulling”
the long side joints together, rather than “pushing” them, making the process even easier. When completed, remove all spacers and
replace the wall base or moldings, leaving a 1/64-inch gap underneath to allow movement.
MAINTENANCE INSTRUCTIONS
Precautions: When performing wet maintenance, prohibit foot traffic until the floor is completely dry. Remove all metal objects
before wetting the flooring. Do not use dust mops treated with oils or silicones, acetone, strong alkaline cleaning agents, multi-
surface cleaners, vinegar/ammonia/ citrus oil solutions, scouring powder, strong solvents, or abrasive cleaning pads, as these can
damage the flooring. The application of a floor-finish is not usually recommended.
Regular Cleaning: Dust mop or vacuum (without a beater bar) the floor to remove any dirt or grit. Clean the floor as often as
required by damp moping using a flat microfiber mop and a suitable diluted vinyl floor cleaning solution (neutral pH), changing the
pad as often as required. Allow the floor to dry before use.
07/03/19
1-inch
from joint