Technical data

Procon
. D C / U T B
The boiler is delivered as a consignment of a palleted carton containing the boiler and associated  ttings,
plus any other optional ancillary  ue or control components in separate cartons.
The boiler carton contains:
• Assembled boiler.
• Wall mounting bracket and associated  xings.
• Fittings bag including, condensate waste outlet, outside air sensor (QAC).
To unpack the boiler, the palleted carton should be laid on the  oor. Carefully cut the nylon bands and lift
the  breboard protective panel. Open the carton top and lift out wall hanging bracket and  ttings bag. Remove
packing material and lift away bottomless carton. With  people, carefully lift the boiler from palleted carton
by holding the rear chassis only.
To remove the casing from the boiler, turn the two casing screws, on the blue casing strip above the control
panel, through °. This will release the casing latches. Pull casing slightly to the front and lift upwards to dis-
engage the casing from the top securing lip. The casing can then be removed.
. B L
The Procon , ,  &  boiler is not suitable for installation external to a building. The position chosen for
the boiler must be a structurally sound wall capable of supporting the weight of the boiler and any ancillaries.
The position should allow for access to a nearby foul water drain suitable to accept condensate water, an
alternative is to install a condensate sump receptacle and condense disposal pump which should remove the
condense water to a remote foul water drain suitable to accept condensate water.
The position of the boiler on the wall must be truly plumb vertical to ensure correct operation of the internal
gravity  ow condense system. The position for the boiler must satisfy the requirements of BS :  or BS
:  as appropriate.
. I C
For ease of installation, commissioning, servicing and maintenance the following clearances should be
observed.
NOTE: These distances are MINIMUM and MUST NOT be reduced. Clearance Dimensions relate to ALL models. Dimensions in { } relate to
model 75 only.
