Instruction Manual
ZG-Mount
Low Profile Mobile Antenna Mount with Thread Stud
DESCRIPTION
Used together with all PROCOM ZG-type antenna whips.
M8x1 thread whip-mounting system.
For installation on horizontal surfaces (roof top or trunk lid) in a 21 mm
dia. hole.
Particularly well suited for rooftop-mounting because of very low internal
protrusion and ability to be installed exclusively with access from the
outside.
Complete line of whips available for all communications bands up to
1300 MHz.
Mounting body made of stainless steel!
Choice between two connection principles:
ZG-mount: FME-connection (supplied without cable).
ZGP4-mount: Permanently attached 4 m cable terminated with FME-
connector.
ORDERING DESIGNATIONS
TYPE NO. PRODUCT NO.
ZG-Mount ZG-mount with FME-system
ZGP4-Mount ZGP4-mount with 4m cable and FME-connector
SPECIFICATIONS
MODEL ZG-MOUNT
APPLICATION Low-profile mount for mobile antennas
FREQUENCY 0-1300 MHz
CONNECTION TO WHIP M8x1 thread stud
MATERIALS Stainless steel
Black chromed brass
Environment-proof plastics
COLOUR Black
HEIGHT Approx. 28 mm
INSTALLATION DIAMETER 38 mm
BUILD-IN DEPTH 10.5 mm
RECOMMENDED
INSTALLATION TORQUE
7.5 ± 1 Nm
WEIGHT ZG-version: Approx. 70 g
ZGP4-version: Approx. 210 g
MOUNTING 21 mm dia. hole
ROOF THICKNESS Max. 2 mm
FME-SYSTEM ACCESSORIES
FME-CABLES
LENGTH TYPE NO.
1 m 1 m FME
2 m 2 m FME
3 m 3 m FME
4 m 4 m FME
5 m 5 m FME
6 m 6 m FME
4 m white 4 m FME-white
6 m white 6 m FME-white
12 m white 12 m FME-white
18 m white 18 m FME-white
FME-CONNECTORS
CONNECTOR ORDER NO.
FME-FME FME-FME
Prolongation FMEP
N FME-N
FSMA FME-FSMA
BNC FME-BNC
TNC FME.TNC
UHF FME-UHF
Mini-UHF FME-MUHF
Elbow-MUHF FME-EMUHF
Elbow-BNC FME-EBNC
Elbow-TNC FME-ETNC
SMA FME-SMA
For further information about other types of FME-cables please compare the cable data sheets under
accessories in our catalogue.
INSTALLATION
The ZG-mount is designed for mounting in a 21 mm dia. hole on horizontal
surfaces as e.g. roof top or trunk lid, with access from the outside only.
A good contact surface on the inside of the car body must always be
ensured, thus enabling the base plate to get in direct contact with the metal
parts of the car, which is of utmost importance for proper performance of
the antenna.
The ZG-mount is provided with an M8 x 1 thread mount system. This
construction meets the demand for a low profile mobile mount with a slim
appearance and with protection against theft of the antenna whip.
When cleaning the car in car-washing machines, the whip is easily removed
using a fork spanner. The whip is refitted again by screwing it onto the
thread stud and tightening it with the spanner.
1. INSTALLATION DIMENSIONS