Owner`s manual

8
7
Operating Instructions
Heater Front View
Remote Control Front
Remote Control Back
Before programming your transmitter you must
first insert two “AAA” batteries.
Make sure the main power on/off switch is “ON”
position.
1. The ON/OFF button:
*Note: When Fireplace is first operated,
the default setting will be: brightest
flame, and full heating To turn on Heater,
press the “ON/OFF” button. Heaters will
be at the last settings before shutting
down. To turn off heater, press the “ON/
OFF” button again.
2. Flame brightness setting:
There are six settings for flame
brightness: “1”,“2”,“3”,“4”,“5” and “6
(OFF)”. Press button to decrease
the flame brightness, and button to
increase the flame brightness.
3. Heating level setting:
There are four settings for heating level:
“HI”, “MID”, “LOW”, and “OFF”. Press
button to decrease the Heating level
and button to increase the Heating
level. If set on “HI”, the set room tem-
perature will be approximately 90°F; set
on “MID”, the set room temperature will
be approximately 80°F; set on “LOW”,
the set room temperature will be
approximately 70°F.
Press “ON/OFF” button to turn on or off the fireplace.
Press “HEAT Adjust” button to control heater.
Press “FLAME ” button to control the Flame brightness.
Manual Operation (without handheld remote)