Installation manual

www.usaprocom.com
23200047-01A
OPERATION
REMOTE CONTROL OPERATION NOTES
The Thermo Feature on the transmitter op-
erates the appliance whenever the ROOM
TEMPERATURE varies a certain number of
degrees from the SET TEMPERATURE.
This variation is called the “swing” or tem-
perature differential. The normal operating
cycle of an appliance may be 4 times per
hour depending on how well the room or
home is insulated from the cold or drafts.
The factory setting for the “swing number” is
2. This represents a temperature variation of
+/-2°F (1°C) between SET temperature and
ROOM temperature, which determines when
the replace will be activated. The transmitter
has ON and OFF manual functions that are
activated by pressing either button on the
face of the transmitter. When a button on the
transmitter is pressed the word ON or OF will
appear on the LCD screen to show while the
signal is being sent. Upon initial use, there
may be a delay of three seconds before the
remote receiver will respond to the transmitter.
This is part of the system’s design.
INSPECTING BURNERS
IMPORTANT: Owner’s should check pilot ame pattern and burner ame pattern often.
Incorrect ame patterns indicate the need for cleaning (see Care and Maintenance,
page 24 or service.
WARNING: Only a qualied service person should service and
repair heater. This includes maintenance requiring replacement or
alteration of components.
PILOT FLAME PATTERN
Figure 26 - Correct Pilot Flame Pattern
(Natural Gas shown)
Figure 27 - Incorrect Pilot Flame Pattern
(Natural Gas shown)
Figure 26 shows a correct pilot ame pattern.
Figure 27 shows an incorrect pilot ame pat-
tern. The incorrect pilot ame is not touching
the thermocouple. This will cause the ther-
mocouple to cool, which shuts the heater off.
If pilot ame pattern is incorrect, as shown
in Figure 27
• turn heater off (see To Turn Off Gas to Ap-
pliance, page 19 or 20)
• see Troubleshooting pages 26 through 28.
WARNING: If yellow tipping
occurs, your heater could pro-
duce increased levels of carbon
monoxide. If the burner ame
pattern shows yellow tipping,
follow instructions at bottom of
this page.
Notice: Do not mistake orange ames with
yellow tipping. Dirt or other ne particles enter
the heater and burn causing brief patches of
orange ame.