Installation Guide
16
INSTALLING LOGS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts spe-
cically approved with this heater may result in property damage or personal injury.
CAUTION: After installation and periodically thereafter, check to ensure that no yellow ame comes in con-
tact with any log. With the heater set to High, check to see if yellow ames contact any log. If so, reposition
logs according to the log installation instructions in this manual. Yellow ames contacting logs will create soot.
Provided Logs: 7
It is very important to install the logs exactly as instructed. Do
not modify logs. Use only logs supplied with heater.
Each log is marked with a number. This number will help you
to identify the logs when installing. It is very important to install
these logs exactly as instructed. Do not modify logs.
After installing logs, add decorative cinders around the grate
base, do not place any decorative cinders on logs or burner.
1. Insert log #1 into slots in rear log
bracket on grate base, and tighten
nuts.
Figure 21 - Installing Log #2
Figure 22 - Installing Log #3&Log#4
Figure 23 - Installing Log #5
Figure 25 - Installing Log #7
Figure 24 - Installing Log #6
1
2
5
4
3
5. Insert the recessed hole on the
bottom of log #5 onto pin on log #1,
with the other end placed on log #2.
6. Insert the recessed hole on
the bottom of log #6 onto pin on
log #2, with the other end placed
on log #4.
4
3
1
2
3. Insert log #3 and log#4 into slots
in front log bracket on grate base
and tighten nuts.
1
2
2. Insert log #2 into slots in middle
grate bracket and tighten nuts.
Figure 20 - Installing Log #1
1
PCD18T
1
2
5
4
3
6
1
2
5
4
3
6
7. Insert the recessed hole on
the bottom of log #7 onto pin on
log #2, with the other end placed
on log #4.
7