Instructions / Assembly

www.usaprocom.com
7200279-01A
Gas Inlet
Elbow Fitting
Gas Inlet
Elbow Fitting
Figure 10
Figure 11
Figure 13
8. Attach the pilot gas pipe assembly to the
safety pilot outlet of the gas control valve
and tighten.
9. Connect the thermocouple to the rear of
the gas control valve.
Gas Control Valve
Gas Control Valve
Safety
Pilot
Safety Pilot
Thermocouple
Ignitor
Pilot Gas Pipe
Assembly
Gas Regulator
Propane/LP
Injector
Gas
Regulator
PROPANE/LP GAS INSTALLATION
5. Attach gas inlet tting to regulator. Use
pipe sealant on the male pipe threads.
6. Attach gas inlet tting and regulator to
gas control valve. Use pipe sealant on
the male pipe threads.
Figure 12
7. The pilot is provided with a natural gas
injector installed. For Propane/LP gas
you must remove it and replace it with the
Propane/LP injector (“LP” printed on the
surface).
Gently loosen and remove the pilot gas
pipe from bracket. Replace the injector
with the Propane/LP pilot injector with
“LP” printed on injector surface. Place and
tighten the pilot gas pipe to bracket.
Figure 14
Gas
Supply
Tube
Gas Inlet
Flare
Fitting
10. Install the gas inlet tting into the inlet
opening of the gas control valve. Use pipe
sealant on the male pipe threads.
11. Carefully shape the gas supply tube and
attach to gas inlet fitting as shown in
Figure 14. Be careful not to cause kinks
in tube.
Gas Regulator