Specifications
7
NOTICE: This heater is in-
tended for use as supplemental
heat. Use this heater along with
your primary heating system. Do
not install this heater as your
primary heat source. If you have a
central heating system, you may
run system’s circulating blower
while using heater. This will help
circulate the heat throughout the
house. In the event of a power
outage, you can use this heater
as your primary heat source.
INSTALLATION
WARNING: A qualified service
person must install heater. Fol-
low all local codes.
WARNING: Electrical
Grounding Instructions
This appliance is equipped with a
three-prong (grounding) plug for
your protection aginst shock hazard
and should be plugged directly into
a properly grounded three-prong re-
ceptacle
WARNING: Never install the
heater
l in a bedroom or bathroom.
l in a recreational vehicle.
l where curtains, furniture,
clothing, or other flammable
objects are less than 36 inches
from the front, top, or sides
of the heater.
l as a fireplace insert.
l in high traffic areas.
l in windy or drafty areas.
WARNING: Maintain the mini-
mum clearances shown in Fig-
ure 4. If you can, provide greater
clearances from floor, ceiling,
and joining wall.
CAUTION: If you install the
heater in a home garage
l heater pilot and burner must
be at least 18 inches above
floor.
l locate heater where moving
vehicle will not hit it.
CHECK GAS TYPE
Use only Natural gas. If your gas
supply is not Natural, do not install
heater. Call dealer where you
bought heater for proper type heater.
LOCATING HEATER
This heater is designed for mount-
ing on a wall, set on floor, away
from a wall.
Purchase optional floor mounting
stand from your dealer.
See Accessories, page 16.
For convenience and efficiency,
install heater
l where there is easy access for
operation, inspection, and service
l in coldest part of room
Figure 4 -Mounting Clearances
As Viewed From Front Of Heater
FASTENING HEATER TO WALL
Mounting Bracket
The mounting bracket is located
on back panel of heater (see
Figure 5). It has been taped there
for shipping. Remove mounting
bracket from back panel.
Figure 5 -Mounting Bracket
Location
CAUTION: This heater creates
warm air currents. These currents
move heat to wall surfaces next
to heater. Installing heater
next to vinyl or cloth wall cover-
ings or operating heater where
impurities (such as tobacco
smoke, aromatic candles, clean-
ing fluids, oil or kerosene lamps,
etc.) in the air exist may discolor
walls.