Specifications

9
Installing Bottom Bracket
(See Figure 10)
1. Install bottom bracket to heater
bottom with two screws. It may
be more convienent to remove
heater from wall mounting bracket
to attach bottom bracket.
2. Place heater on mounting bracket.
3. Locate two bottom mounting
holes on wall. These holes are
near bottom on heater.
4. Mark screw locations on wall.
5. Remove heater from mounting
bracket..
6. If installing bottom mounting
screws into hollow or solid wall,
install wall anchors. Follow steps
1 through 4 under Attaching
To Wall Anchor Method. If
installing bottom mounting screw
into wall stud, drill holes at marked
locations using 9/64" drill bit..
7. Replace heater onto mounting
bracket..
8. Tighten both screws until heater
is firmly secured to wall. Do not
over tighten.
Figure 10 - Installing Bottom Bracket
CONNECTING TO GAS
SUPPLY
IMPORTANT : Check your gas
line pressure before connecting
heater to gas line.Gas line pres-
sure must be no greater than 14
inches of water.If gas line pres-
sure is higher,heater regulator
damage could occur.
Figure 11- Gas Meter
INSTALLATION
CONTINUED
WARNING: A qualified service
person must connect heater to
gas supply. Follow all local codes.
WARNING: This appliance re-
quires a 3/8" NPT (National Pipe
Thread) inlet connection to the
pressure regulator.
WARNING: Do not over tighten
gas connections.
WARNING: Never connect
heater to private ( non-utility )
gas well.This gas is commonly
known as well-head gas.
CAUTION: Use only new, black
iron or steel pipe. Internally-tinned
copper tubing may be used in
certain areas. Check your local
codes. Use pipe of large enough
diameter to allow proper gas volume
to heater. If pipe is too small,
undue loss of pressure will occur.
CAUTION: Use pipe joint
sealant that is resistant to
natural gas.
CAUTION: Avoid damage to
regulator. Hold gas regulator with
wrench when connecting to gas
piping and/or fittings.
*A CSA/AGA design-certified equip-
ment shutoff valve with 1/8" NPT
tap is an acceptable alternative to
test gauge connection.
INSTALLATION NEEDS
Before installing heater, make sure
you have the items listed below.
l piping (check local codes)
l sealant (resistant to Natural
gas)
l equipment shutoff valve*
l ground joint union
l test gauge connection*
l sediment trap
l tee joint
l pipe wrench