Specifications
3
SAFETY INFORMATION
9. Do not use heater if any part
has been under water.
Immediately call a qualified
service technician to inspect
the room heater and to replace
any part of the control system
and any gas control which has
been under water.
10. Turn off heater and let cool
before servicing. Only a qualified
service person should service
and repair heater.
WARNING: Do not use any
accessory not approved for
use with this heater.
WARNING: Any change to
this heater or its controls can
be dangerous.
1. This appliance is only for use
with the type of gas indicated
on the rating plate. This
appliance is not convertible for
use with other gases.
2. If you smell gas
l Shut off gas supply.
l Do not try to light any appliance.
l Do not touch any electrical
switch, do not use any phone in
your building.
l
Immediately call your gas
supplier from a neighbor’s
phone. Follow the gas
supplier’s instructions.
l If you cannot reach your gas
supplier, call the fire department.
3. This heater shall not be
installed in a bedroom or
bathroom
4. This heater needs fresh,
outside air ventilation to run
properly. This heater has an
Oxygen Depletion Sensor
(ODS) safety shutoff system.
The ODS shuts down the
heater if not enough fresh air
is available. See Fresh Air for
Combustion and Ventilation
pages 5 and 6.
5. Keep all air openings in front
and bottom of heater clear
and free of debris. This will
insure enough air for proper
combustion.
6. If heater shuts off. Do not
relight until you provide fresh,
outside air. If heater keeps
shutting off, have it serviced.
7. Do not operateT
l Where flammable liquids or
vapors are used or stored
l Under dusty conditions
8. Before using furniture polish,
wax, carpet cleaner, or similar
products, turn heater off. If
heated, the vapors from these
products may create a white
powder residue within burner
box or on adjacent walls or
furniture.
SAFETY PILOT
This heater has a pilot with an
Oxygen Depletion Sensor(ODS)
safety shutoff system. The ODS/
pilot shuts off the heater if there is
not enough fresh air.
AUTOMATIC IGNITION
SYSTEM
This heater is equipped with an
automatic system.
This system requires no
matches, or batteries to light
heater.
TOUCH PAD THERMO-
STATIC HEAT CONTROL
This heater has a control module
with a thermostat sensing bulb.
Set desired temperature with touch
pad . This results in the greatest
heater comfort and may result in
lower gas bills.
MANUAL OVERRIDE
CONTROL SYSTEM
(MN200EHPC, MN300EHPC)
There are two control systems,
electric and manual override.
If no electric power is available,
you can operate heater by
manual override.
LOCAL CODES
This heater is designed for vent-free
operation. Some state and local
codes prohibit the use of vent-free
heater.
11. Operating heater above
elevations of 4,500 feet could
cause pilot outage.
WARNING
Modles MN200EPC MN200EHPC
MN300EPC MN300EHPC are equipped
for natural gas. Field conversion is
not permitted.
Do not place clothing or other
flammable material on or near
the appliance. Never place any
objects on the heater.
Due to high temperatures, heater
should be kept out of
traffic and away from furniture
and draperies.
Keep the appliance area clear
and free from combustible
materials, gasoline, and other
flammable vapors and liquids.
Make sure grill guard is in
place before running the heater.
Carefully supervise young
children when they are in the
same room with heater.
Front surface of heater becomes
very hot when running heater.
Keep children and adults away
from hot surface to avoid burns
or clothing ignition. Heater will
remain hot for a time after shut
down. Allow surface to cool
before touching.