Product specifications

INSPECTING BURNERS

Check pilot ame pattern and burner ame patterns often.

PILOT FLAME PATTERN

1. Turn control knob to pilot position

2. Inspect pilot ame and refer to Fig. 15 and 16.

• Fig. 15 shows a correct pilot ame pattern.

• Fig. 16 shows an incorrect pilot ame pattern. The incorrect pilot ame is not touching the

thermocouple. This will cause the thermocouple to cool. When the thermocouple cools, the

heater will shut down.

• If the pilot ame is incorrect, as shown in Fig. 16, turn heater off (see “To Turn Off Gas to

Appliance," page 20). See Troubleshooting, page 24 - 26.

Fig. 17 - Correct Pilot Flame Pattern with

Control Knob Set to High Flame (5)

Fig. 18 - Incorrect Pilot Flame Pattern with

Control Knob Set to High Flame (5)

BURNER FLAME PATTERN

Fig. 17 shows a correct burner ame pattern. Fig. 18 shows an incorrect burner ame pattern.

• If burner ame is incorrect, as shown in Fig. 18, turn heater off (see “To Turn Off Gas to

Appliance”, page 20).

• see Troubleshooting, pages 24 through 26.

BURNER PRIMARY AIR HOLES

Air is drawn into the burner through the holes in the tting at the entrance to the burner.

These holes may become blocked with dust or lint. Periodically inspect these holes for

any blockage and clean as necessary. Blocked air holes will create soot.

Fig. 15 - Correct Pilot Flame Pattern Fig. 16- Incorrect Pilot Flame Pattern

More than 8 in above top of logs

Approx. 3-6 in above top of logs