Installation manual
Table Of Contents
- Safety
- Specifications
- Qualified Installing Agency
- Product Features
- Local Codes
- Preparing For Installation
- Unpacking
- Water Vapor: A By-Product Of Unvented Room Heaters
- Air For Combustion and Ventilation
- Installation
- Operation
- Inspecting Heater
- Care And Maintenance
- Troubleshooting
- Parts
- Replacement Parts
- Accessories
- Service Hints
- Technical Service
- Warranty
- 200000-01B Spn.pdf
- Seguridad
- Especificaciones
- Agencia de Instalación Calificada
- Características del Producto
- Normas Locales
- Preparación Para la Instalación
- Desempaque
- Vapor De Agua: Un Producto Derivado de Los Calentadores de Habitación Sin Ventilación
- Aire para combustión y ventilación
- Instalación
- Funcionamiento
- Inspección del calentador
- Cuidado y mantenimiento
- Solución de problemas
- Piezas de repuesto
- Accesorios
- Consejos para servicio
- Servicio técnico
- Piezas
- Garantía
www.usaprocom.com
200000-01B20
OPERATION
MANUAL LIGHTING PROCEDURE
(ALL MODELS)
1. Remove lower front panel.
2. Follow steps 1 through 5 under Lighting
Instructions, page 18 or 19.
3. With control knob pressed in, strike match.
Hold match to pilot until pilot lights.
4. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Follow step 8 under
Lighting Instructions, page 18 or 19.
5. Replace lower front panel.
Figure 21 - Pilot Assembly
Pilot Air
Inlet Hole
Natural
Gas
Burner
Propane/LP
Gas Burner
Ignitor
Electrode
Thermocouple
Pilot Air Inlet Hole
TO TURN OFF GAS TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise to the
OFF position.
2. Turn off all electric power to the appliance
if service is to be performed.
Shutting off burner only
(pilot stays lit)
Turn control knob clockwise to the
PILOT/IGN position.