Use and Care Manual

BUILT-IN FIREPLACE INSTALLATION

Built-in installation of this replace involves installing

replace into a framed-in enclosure. This makes the front

of the replace ush with wall. If installing a built-in mantel

above the replace, you must follow the clearances shown

in Fig. 5. Follow the instructions

NOTICE: Surface temperatures of adjacent walls and

mantels become hot during operation. Walls and

mantels above the replace may become hot to the

touch. If installed properly, these temperatures meet

the requirement of the national product standard.

Follow all minimum clearances shown in this manual.

See Fig. 6.

1. Frame in rough opening. Use dimensions shown in Fig. 7

for the rough opening. If installing in a corner, use

dimensions shown in Fig. 8 for the rough opening. The

height is 26 1/2 -in., which is the same as the wall

opening above.

2. Carefully set replace in front of rough opening with back

of replace inside wall opening.

3. Attach gas line to replace gas regulator. See "Connecting

to Gas Supply," page 13.

4. Check all gas connections for leaks. See “Checking Gas

Connections,” page 16.

Fig. 7 - Rough Opening for Installing in Wall

Fig. 5 - Clearance to Combustibles

Fig. 6

NOTE: When heater is installed directly on carpeting, tile or other combustible material, other than wood ooring, the heater

must be installed on a metal or wood panel extending the full width and depth of the heater.

Note All vertical

measurements are

from top of replace

opening to bottom

of mantel shelf. All

measurements are

in inches.

Side of

Firebox

Mantel Shelf

Note: Height of replace opening on facia to 23 ¼ inches

3/4 in. Clearance to facia

in. Clearance to Sides, Back and Top