Installation Guide

6
1. Remove the natural gas burner inlet tting
from the burner pan assembly as shown in
Fig. 1. DO NOT remove the orice from this
tting.
Fig. 1
Fig. 2
2. The propane/LP burner air mixer (A)
included in this kit has 6 holes and must be
used to replace the natural gas inlet
tting. Be sure to use the correct
propane/LP orice for your appliance. This
kit contains additional orices (G or I) as
shown in Fig. 2.
A
G I
or
If you have a 24 in. log set, then the
24 in. propane/LP orice (H), shown in the table
below, is already installed in the propane/LP
burner air mixer (A). Proceed to step 3.
7. When installing this kit on the left hand side of
the burner, adhere control instruction label (N)
onto valve cover (L) as shown in Fig. 7.
Fig. 7
N
L
OFF
PROPANE/LP GAS INSTALLATION