Use And Care Manual

www.usaprocom.com
7200070-01E
Figure 12 - Removing Grill from Fireplace
Figure 13 - Removing Screws from
Control Panel
Figure 14 - Inserting Rocker Switch Wires
12.
Remove 2 screws securing grill to stove
front. Carefully set grill aside (see Fig
-
ure 12).
AUTO
OFF (O)
MAN
Rocker Switch
Figure 15 - Connecting Wires to Rocker
Switch
Figure 16 - Installing Rocker Switch
Figure 17 - Protection Tab on Top Cover
13. Remove logs and carefully set aside. Note
log placement before removing.
14. Remove 2 screws securing control panel.
Pull the control panel out without discon-
necting the ignitor wire (see Figure 13).
IGNITOR
15. Feed the AUTO, OFF, MAN connectors
through the rocker switch hole on the left
side of the control panel (see Figure 14).
16. Connect the AUTO, OFF, MAN wires to
the three corresponding male tabs on the
rocker switch (see Figure 15).
INSTALLATION
-
ED SERIES
17. Push the rocker switch into the control
panel (see Figure 16).
18. Reattach the control panel with two screws
removed in step 14 (see Figure 13).
19. Reinstall logs according to original layout.
Refer to owner's manual for log place-
ment.
20. Install grill with 2 screws removed previ-
ously (see Figure 12).
21. Replace top cover (see Figure 1, page 5).
22. Push the protection tab to embed it into
the surface of the top cover (see Figure
17).