Use And Care Manual

www.usaprocom.com
5200070-01E
AA
WARNING: Before installing
the blower, be certain to turn o󰀨
the unit, and allow time for unit
to cool down.
1. Unscrew and remove top cover of the
replace (see Figure 1).
Figure 1 - Remove Fireplace Top Cover
Figure 2 - Installing Power Cord
Figure 3 - Attaching Blower to Top Cover
2. Attach the power cord to the replace top
cover with 3) M4.2X8 screws (AA) (see
Figure 2).
3. Attach the blower assembly to the top
cover with 4) M4.2X8 screws (CC) (see
Figure 3).
AA
CC
INSTALLATION
-
ED SERIES
Figure 4 - Installing Grounding Terminal
to Top Cover
4. Attach the grounding terminal to top cover
with 1) M4.2X8 screw (AA). Refer to wiring
diagram, page 15. Be sure to insert the
gasket between the protection tab and
the grounding terminal (see Figure 4).
Figure 5 - Connecting Blower Wire to
Wire Connector
5. Insert the blower connector (male port)
into the female port on the wire connector.
This protects the jacket in the replace
(see Figure 5).
Grounding
Terminal
Gasket
Protection Tab
Male Port
Female
Port