Use And Care Manual

www.usaprocom.com
200070-01E
14
GROUNDING INSTRUCTIONS
This heater is for use on 120 volts. The
cord has a plug as shown at A. An adapter
as shown at C is available for connecting
three-blade grounding-type plugs to two-slot
receptacles. The green grounding lug ex-
tending from the adapter must be connected
to a permanent ground such as a properly
grounded outlet box. The adapter should not
be used if a three-slot grounded receptacle
is available.
Grounding Pin
Grounding Means
Metal Screw
Cover of
Grounded
Outlet Box
A
B
C
Adapter
OPERATION
Using rocker switch, turn blower on and
check for operation. Turn on rocker switch to
the desired position. In the MAN position the
blower will remain constantly on. In the AUTO
position the blower will be controlled by the
temperature sensor. To stop the operation turn
rocker switch to the O position.
CARE AND MAINTENANCE
Always disconnect the appliance
from the main power supply and
allow it to cool before any servic-
ing operation.
The motors used on the fan heater and ame
blower are pre-lubricated for extended bearing
life and require no further lubrication.
Periodic cleaning/vacuuming of the appliance
around the air intake and exhaust, as well as
the fan heater is recommended. For heavy
or continuous use, periodic cleaning must
be done more frequently. If the heater blows
alternating cold and warm air, check the fan
for free movement and for debris restricting
air ow. If the fan does not move freely, the
unit must be turned o󰀨 and the fan replaced
immediately in order to prevent further dam-
age to the unit.