Full Product Manual
www.usaprocom.com
200239-01A18
INSTALLATION
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation
and periodically thereafter,
check to ensure that no yellow
ame comes in contact with any
log. With the heater set to High,
check to see if yellow ames
contact any log. If so, reposi-
tion logs according to the log
installation instructions in this
manual. Yellow ames contact-
ing logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs. Use only
logs supplied with heater.
Each log is marked with a number. This
number will help you to identify the logs when
installing.
After installing logs, add decorative cinders
around the grate base, do not place any
decorative cinders on logs or burner.
Model PCNSD18T Shown. 24" log sets
have a different appearance, but install
the same.
1. Insert log #1 into slots in rear log bracket
on grate base.
2. Insert log #2 into slots in middle grate
bracket.
3. Insert logs #3 and #4 into slots in front
grate bracket.
4. Place logs #5, #6 and #7 as shown in
Figure 22.
Figure 21 - Installing Logs #1 through #4
Figure 22 - Installing Log #5, #6 and #7
Figure 23 - 24" Log Set
Log #1
Log #2
Log #3
Log #4
Log #5
Log #7
Log #6