Use And Care Manual

www.usaprocom.com
200016-01D
8
Figure 14 - Attaching Blower to Power
Cord
4. Insert the male port from the blower as-
sembly into the corresponding female port
from the power cord, (see Figure 14).
Blower
Assembly
Female Port
Male Port
5. Connect the AUTO, OFF, MAN wires to
the three corresponding male tabs on the
rocker switch (see Figure 15).
AUTO
OFF (O)
MAN
Rocker Switch
Figure 15 - Connecting Wires to Rocker
Switch
Figure 16 - Installing Rocker Switch
(PC Series Shown)
Figure 17 - Connecting P1 Wires
Figure 18 - Connecting P2 Wires
6. Feed the harness back through the open-
ing and push the rocker switch housing
into the mounting hole until tightly seated
ush to the panel (see Figure 16).
Note: See page 4 for rocker switch hous-
ing location for your model replace.
MAN O AUTO
7. Insert the female port, which is on the
white power supply wire (marked with P1),
into the corresponding male port. (marked
with P1), (see Figure 18).
P1
P2
8. Insert the male port, which is on the black
power supply wire (marked with P2), into
the corresponding female port (marked
with P2), (see Figure 17).
CONNECTING POWER SUPPLY