User Guide

QUICK START GUIDE
PSC6194 Controller
PROCESS SOLUTIONS CORP.
(281)-491-3833
SALES@PSCTEXAS.COM 15
Configure Units
Units Page
Totalizer Unit
To configure the totalizer units, press the box
below the
Unit label, as shown by the X, to
navigate to the corresponding
Units Page.
Once at the Unit Page, press the desired Unit
once and allow up to 5 seconds to update.
The configured unit will be displayed at the
bottom left corner.
The Units available to configure from will depend
on the Instrument Mode. Instrument Mode must
be configured by FlowDDE.
Instrument Modes:
Mass Flow, Normal Volume Flow, Standard
Volume Flow, Volume Flow (Actual)
Totalizer Unit supports the following values:
Volume Flow l, mm3, ml, cm3, ul, m3
Normal/Standard Volume Flow ln, mm3n, mln,
cm3n, uln, dm3n, m3n, ls, mm3s, mls, cm3s, uls,
dm3s, m3s
Mass Flow g, mg, ug, kg
EXIT Return to previous screen without saving.
HOME Return to Main Screen
Configure Limit
Totalizer Limit
The Totalizer Limit is displayed in units selected
with parameter
Unit.
To edit the Totalizer Limit, press the number box
below the Limit Label, as shown by the X.
Red Border when
Value reaches Limit.
ENTER Save value and return to previous
screen.
ESC Return to previous screen without saving.