Operating instructions

Cleaning
Asphalt
Pump
1. V/ith
the 3" unloading hose
connected
to the pump
discharge pipe, put
the
loose
end of the hose
in a
bucket
2.
Check the area for
sources of flame,
lit
cigarettes, torches
or lighters.
Extinguish
all sources
of flame.
3. Put the end
of the small
(3/8")
hose
which
is
attached to
the breather
vent valve in
a bucket of diesel
fuel or kerosene.
4.
Open the breather
vent valve
between the
pump
and
the hose.
5.
Hold
both hoses
to avoid being
splashed.
6. While holding
the hoses
securely,
turn the
pump
switchto
forward
momentarily.
This
will draw the
solvent
from the diesel
fuel bucket, pump
it
through the pump
and
out
into
the catch bucket.
7,
Shut
pump
off.
8,
Drain
the remaining
solvent
from the
three inch
hose into the
catch bucket.
9. Close the
breather vent valve
between
the
pump
and the
3/8"
hose.
WashouWent
Valve
3/8" Hose
Qnr-r-
Diesel Fuel Buckel
Catch Bucket
Cleaning
Asphalt Pump
A
woRNrNG
Extinguish
all sources of flame,
lit
cigarettes, torches or lighters.
3u
Unloading
Hose
A
*nRNtNG
All
surfaces
and equipment
should
be
considered
to be hot. Wear
insulated
gloves
and
protective
clothing
to
prevent
burns.
A
*aRNtNc
Do
not
open
valves
unless
you
are
prepared
for
asphalt to flow. The
liquids
stored
in
this tank are hot.
(
i
l4