Specifications

programming

memory buttons

To program the Memory Buttons, follow these steps:

1 Select the section that you wish to program the Memory But-

ton in by pressing the corresponding Device button (audio or

sat) and mute button, simultaneously. SET will appear in the

LCD.

2 Press one of the Memory Buttons (m1, m2, m3, m4 or power/

standby

) into which you wish to store the functions. M(1-

5)_##

will appear in the LCD.

NOTE: The mute button is used to designate POWER/STANDBY commands

during Memory button programming.

3 Press in up to fifteen commands that you want stored in that

Memory button. Each successive button selection will appear

as M(1-5)_(01-15) in the LCD.

You can select functions from another mode by first pressing

the corresponding Device button and then the buttons where

those functions are located in that mode. The pressing of a

Device button also counts as one command.

NOTE: Each insertion of a Device Button adds a 1/2-second delay to the

command sequence.

4 Press the channel + button to store your selections. SAVE will

flash three times in the LCD to confirm the programming.

IMPORTANT NOTE: If you attempt to store more than 15 commands, the entire

sequence of macros entered will clear and you will need to start over.

NOTE: It can take up to 15 seconds to send out 15 commands from a memory

button. Please continue to point the remote control at the device(s) until all the

commands on the Memory Button have been sent out. This will ensure that all

the commands are received by the device(s).

Example: To program your TV, Cable Box and the PRE to turn on when the

power button is pressed, first press-and-hold the sat and mute buttons until SET

appears in the LCD. Next, press the mute button to enter the Power commands

for the PRE. Press tv to select the TV mode, and then press the mute button

again, to select TV Power. Finally, press cbl followed by the mute button to

select Cable power. Press the channel + button to enter the commands.

After following these steps, each time you press the power/standby button,

after either the sat, tv, vcr or cbl Device control selector has been pressed, the

remote will send the “Power On/Off” command.