Specifications

23
learning new functions on the
main keypad
1 Select the mode in which you wish to learn the new function
by pressing the corresponding Device button.
2 Place the PRE remote and the original remote control to be
learned from, on a flat surface. Line up the remote controls
head-to-head, about two to three inches apart.
audio
pre
cd dvd aux
cblvcrtvsat
standby
mute
power
input
prev
record
adjust channel
next
volume volume
play
rev fwd
pause
stop
2" to 3"
audio
pre
cd dvd aux
cblvcrtvsat
standby
mute
power
input
prev
record
adjust channel
next
volume
volume
play
rev fwd
pause
stop
Device Buttons
Play Button
3 Press and hold both the Device button selected in Step 1
and the play button for about three seconds, until the LCD on
the PRE remote shows LEARN. the PRE remote is now in the
learning mode.
NOTE: Each of the following steps must be completed within 20 seconds. If
the remote does not receive any new commands within the allotted time, it
will return to its normal operating mode.
4 Press and release a button on the PRE remote you have
selected to learn the new function. The LCD will show
READY.
5 Press and hold the button on the original remote control for
about 3 seconds from which you are learning the new function.
The LCD on the PRE remote will show – – – – indicating that it
is receiving the information from the original remote control.
6 Release the button on the original remote control. The LCD
on the PRE remote will show RETRY.
7 Press and hold the same button on the original remote once
again, for about three seconds. The LCD on the PRE remote
will flash GOOD, the Device Mode and then return to LEARN,
verifying that the new function has been learned.
Repeat Steps 4 through 7 for any other buttons you wish to learn new
functions.
8 Once you have completed the learning for all the desired but-
tons in a Device mode, store the learned functions by press-
ing the device and play buttons simultaneously, once again.
The LCD in the PRE remote will show SAVED and then return
to
the Device Mode. The remote has now returned to the origi-
nal operating mode.
Once you have stored the learned functions, test the buttons that have been
taught. If any of the buttons do not operate as they should, please repeat from
Step 1 for those buttons.
NOTE: If the LCD shows FAIL at any time during the learning process, the PRE
remote was unable to learn the new functions. Please repeat from Step 4. If
the remote continues to show FAIL during the learning process, please try the
following suggestions: