Specifications

20
audio
pre
cd dvd aux
cblvcrtvsat
standby
mute
power
input
prev
record
adjust channel
next
volume
volume
play
rev fwd
pause
stop
vcr1 vcr2 laserdisc polarity
tv/vcr1 cd1 cd2 mode
tape1 tape2 bal/aux status
entermenu
46
9
123
5
78
on
screen
display input delay recall
subrearcenterbalancemaster
mono
m1 m2
light
m3
path
m4
tuner
0
mute
standby
power
cd2
6
bal/aux
9
cd1
5
tape1
7
tape2
8
display
balance
mono
path
volume
volume
polarity
tuner
0
•
1 LCD DISPLAY
This Liquid Crystal Display (LCD) shows messages as to which Device
Mode the remote is currently in, as well as various messages displayed
while programming your remote.
2 PROGRAMMING STATUS LED
This three-color (green/red/orange) LED indicates the remote’s status
when IR commands are being transferred from another compatible IR
remote. For more information on “teaching” the remote to learn IR
commands see Programming and Using the Remote Control.
3 DEVICE CONTROL SELECTORS
Press the
pre/audio button to use the remote control for operation of
the PRE Preamplifier. Note that the Programming Status LED will briefly
blink red and the LCD Display will confirm your selection by switching
to AUDIO.
Press any of the other seven Device Control Selectors to use the remote
to control the functions of another audio/video device.
4TRANSPORT BUTTONS
This section of the PRE learning remote control groups the most-used
features of a source component together, be it a CD player, a VCR, or
a laserdisc player. This design allows you to put one or more of the
remote controls in your coffee-table collection away in a drawer, leaving
only the single PRE remote to provide all of the day-to-day commands
you require.
5 NUMERIC KEYPAD
The numeric keypad of the PRE learning remote control can be
“taught” to emulate the numeric keypad you might have on the remote
controls of your cable decoder or television.
6 MEMORY BUTTONS
There are five memory buttons (m1~m4, power) that are designed to
store up to 15 commands in each button. Pressing any one of the memory
buttons will send out the series of commands that are stored in the button.
These buttons can be programmed to store Favorite Channels, Macro
Commands, or to “relocate” functions from one mode to another.
7 LIGHT BUTTON
All buttons and the LCD on the PRE remote are back-lit for seven
seconds when the light button is pressed. The backlight is extended
an additional seven seconds with any button press while the backlight
is on.