Specifications

9
COMPLETE ENGINE IMMOBILISATION
60 sec after the instrument panel has been turned off (+15 OFF), it will no longer be possible to start the engine up again.
If the correct password is keyed in when the instrument panel is on (+15 ON), this function is neutralised.
The system can also be neutralised using the RESTORING THE OVERRIDE CODE procedure (refer to relative section).
TEMPORARY BLOCK
If 3 wrong codes are keyed in consecutively, the system enters a temporary blocked mode and does not accept any further
attempts for 10 minutes, making 3 consecutive Beeps every 5 sec (the instrument panel must remain switched off +15 OFF).
It is possible to key the correct password in only at the end of this timed stage with the instrument panel turned on (+15 ON).
If a further 3 wrong codes are keyed in, the temporary blacked mode will last for 20 minutes, then 30 minutes...
NEUTRALISING THE ANTI CARJACKING
By keying in a 4-digit password on the KEY PAD 4 when the instrument panel is turned on (+15 ON). If the correct code is keyed
in, a long BEEP will be heard, whereas the wrong code will result in 3 consecutive Beeps.
18 - SIREN SUPPLIED - Factory Setting: according to the type of siren supplied
The alarm system can be supplied with either the M02 siren or the SC1 siren with battery back up. If you want to change the
siren supplied with the other version, the setting of this function must be changed accordingly.
19 - KEY 4 KEYPAD - Factory Setting: disabled
The keypad replaces the LED/SWITCH and electronic emergency keys set (which can not operate together with the keypad). It
is complete with a LED for signalling the status of the alarm system, a buzzer and 4 backlit keys (these light up the first time
one of them is pressed and remain lit for 15 seconds after they were pressed for the last time).
20 -
SAFETY LOCK CONTROL - Factory Setting: mileometer
See function 3
21 -
DISTRACTION-PROOF REARMING FUNCTION - Factory Setting: disabled
This function enables the control unit to rearm the alarm system completely 2 minutes after it was last disarmed by remote
control, provided the status of the doors, boot and bonnet remains unchanged during this time. If the volumetric protection was
excluded when the system was previously armed, it will be excluded again when the system is automatically rearmed.
22 -
FUNCTION OF REMOTE CONTROL BUTTONS
The way the buttons on the alarm system’s remote control operate can be customised as shown in the table below: the system
is supplied with the complete set of factory settings.
23 -
PASSIVE ARMING WITH ALARM FUNCTIONS - Factory Setting: disabled
This allows the peripheral protection of the alarm system to be armed automatically 30 seconds after the last open door is
opened and the instrument panel is switched off (+15 OFF). The direction indicators flash 2 times to signal the system is armed
and the LED flashes very quickly during the initial immunity time to indicate that the volume protection is not operational.
After the initial immunity time, any alarm stimulus will trigger a PRE-ALARM signal lasting 5 seconds during which the siren will
make a series of BEEP sounds: if the system is not disarmed before this time is over, a full alarm cycle will be triggered at the
end of the pre-alarm signal. The alarm can be disarmed by means of the remote control.
Automatic passive arming can be temporarily neutralized with the garage function (see relative section)
24 -
PASSIVE ARMING OF IMMOBILISER - Factory Setting: disabled
This allows the immobiliser to be armed automatically by the control unit:
- 4 minutes after the engine has been turned off, or
- 50 seconds after a door has been opened if the engine has been turned off
Automatic passive arming can be temporarily neutralized with the garage function (see relative section)
25 - PERIPHERAL ALARMS ACTIVE - Factory Setting: derived (1 alarm only)
It is possible to choose if an ongoing alarm trigger is to correspond to a single alarm cycle, or to consecutive alarm cycles up
to a maximum of 10 (European Directive)
ARMING: with manual and automatic comfort closing of
electric windows, if selected by installer
DISARMING: the system will rearm completely unless you
enter the interior within 2 minutes and the distraction-proof
function is enabled
EXCLUSION OF ULTRASONIC VOLUME PROTECTION AND
AUXILIARY MODULES: press within 25 sec. of arming
STOP ALARM CYCLE: without disarming the system
PANIC: can be triggered when control unit is armed, after
initial immunity time, max 10 sec. duration, can be stopped
FUNCTION
BUTTON A
BUTTON A
BUTTON B
1st press US
2nd press auxiliary
modules
BUTTON B
BUTTON B
Can also be trigged
if control unit is
disarmed
BUTTON A
1st press US
2nd press auxiliary
modules
BUTTON A
BUTTON A
BUTTON A
BUTTON B
FACTORY SETTING
CUSTOM SETTING