Specifications

12
KEY IN CODE
EG.1324:
ALARM HAS BEEN
ARMED FOR AT LEAST
25 SEC.
KEYPAD PROCEDURE
1 BEEP
1 BEEP
1 BEEP 1 BEEP
1 LONG
BEEP
KEY IN CODE
EG. 13212:
press the switch
immediately
after the same number of
flashes by the LED as the
individual digit of
the OVVERIDE code
WITHIN 10 SEC
ON
OFF
LED ON
WITHIN 1,5 SEC
1 FLASH
X2
CONTROL
UNIT
DISARMED
LED/SWITCH PROCEDURE
ON
OFF
LED ON
PROTEZIONE
ANTIRAPINA
IN ESECUZIONE
ON
CONTROL UNIT DISARMED
OR CARJACKING PROTECTION
NEUTRALISED
1 BEEP
WITHIN 10 SEC
3 FLASHES 2 FLASHES
1 FLASH
1 FLASH
WITHIN 1,5 SEC
WITHIN 1,5 SEC
WITHIN 1,5 SEC
WITHIN 1,5 SEC
WITHIN 10 SEC
WITHIN 10 SEC
WITHIN 10 SEC
WITHIN 10 SEC
WITHIN 10 SEC
WITHIN 10 SEC
USE OF THE OVERRIDE CODE
This procedure is only operational after the initial immunity time or after the anti carjacking protection has become operative.
Alarm cycles will be triggered as the code is being keyed in. If the LED/SWITCH does not work, it is also possible to insert the
code by turning the vehicle’s ignition key ON and OFF instead.
When the alarm system is armed, or when the anti carjacking protection is operational, follow the procedure illustrated below
to disarm the H.P.A. control unit.
ALARM HAS BEEN ARMED
FOR AT LEAST 25 SEC. OR
ANTI CARJACKING
PROTECTION IS
OPERATIONAL
WARNING: if the wrong code is keyed in 3 times, the control unit will be blocked for 10 minutes to prevent attempts to acquire
the code.
RESETTING THE OVERRIDE CODE
Should the code be lost or forgotten, the 1 1 1 1 1 factory set code, or 1111 with keypad, can be restored, and the owner’s
new code stored in again. This operation is not feasible if the system is armed (it must first be disarmed) but it can be
implemented if the vehicle is blocked or if there is an anti-carjacking alarm. In automatic anti-carjacking 2 mode, it is only
possible to implement it in the final, temporary immobilisation stage. This operation does however allow you to exit the anti-
carjacking phase. You must have both remote controls to do this and follow the procedure below:
- disarm the control unit;
- turn the vehicle’s ignition key ON (dashboard turned on);
- press button A on one of the 2 remote controls;
- press button A on the second remote control;
- press button A on the first remote control again;
- press button A on the second remote control again. The M02 siren will now confirm that the code has been reset by sounding
2 BEEPS followed by 2 BOOPS. The SC1 siren will make 2 BEEPS followed by 4 BIPS.
- turn the vehicle’s ignition key OFF (dashboard turned off);
N.B. Make sure that less than 5 seconds pass between one step and the next.