Specifications

10
CONTROL UNIT
DISARMED
1 Beep
KEY IN STANDARD
CODE 11111:
Press the switch
immediately after
the same
number of flashes by the
LED as the individual
digit
of the OVERRIDE code
WITHIN 1,5 SEC.
ARM DE
ALARM
X4
FLASH
X1
X1 X1 X1 X1
WITHIN 10 SEC.
ON
OFF
M02 = 4 Boop
SC1 = 8 Bip
WRONG
CODE
CORRECT
CODE
M02 = 2 Beep
2 Boop
SC1 = 2 Beep
4BIp
KEY IN CUSTOMISED
CODE EG. 13212:
Press the switch
immediately after
the same number
of flashes by the LED
as the individual digit
of the OVERRIDE code
WITHIN 1,5 SEC.
FLASH
X1
X3 X2 X1 X2
M02 = 2 Beep
2 Boop
SC1 = 2 Beep
4BIp
LED ON WITHOUT
FLASHING
WITHIN 10 SEC.
WITHIN 10 SEC.
FLASH
FLASH
FLASH FLASH
WITHIN 1,5 SEC.
WITHIN 1,5 SEC.
WITHIN 1,5 SEC. WITHIN 1,5 SEC.
FLASH
FLASH
FLASH
FLASH
WITHIN 1,5 SEC.
WITHIN 1,5 SEC.
WITHIN 1,5 SEC.
WITHIN 1,5 SEC.
WITHIN 10 SEC.
ON
OFF
WITHIN 10 SEC.
WITHIN 10 SEC.
ON
OFF
WITHIN 10 SEC.
ON
WITHIN 10 SEC.
OFF
WITHIN 10 SEC.
THE OVERRIDE CODE
In emergency situations, the alarm system can be neutralized by means of the OVERRIDE code. This is keyed in by using the
button on the SWITCH/LED mounted on the dashboard or via the KEY4 keypad, if present. The code set during production in
the factory is the same for all control units, i.e. 1 1 1 1 1 or 1111 if the keypad is enabled.
It is absolutely essential to customise this code; ask the owner of the vehicle for a sequence of 5 digits of his choice, not
including 0, if the SWITCH/LED is mounted. If the keypad has been mounted the code has 4 digits made up of the keys 1, 2, 3
and 4 on the keypad. This code must be stored in the control unit’s memory as shown in the procedure below, and then noted
on the OVERRIDE CARD provided with the system and kept in a safe place by the owner of the vehicle.
CUSTOMISING THE OVERRIDE CODE WITH SWITCH/LED