User guide

821116: AMP2-16V Series User Guide

Chapter 3 The “How Do I...” Chapter

Frequently Asked Questions

How Do I Terminate/Unterminate AES Inputs?

AES signals should have one and only one termination. This

termination should physically be at the last destination of an AES coax

cable. If the AMP2-16V is the last connection in a series of AES

connection, then its terminations should be turned on. By default, the

AES inputs of the AMP2-16V are all terminated.

A symptom of too many terminations (or no termination) is that no

signal appears to be present on the AES input.

The termination setup is done in the AES Input Configuration

Figure 3–25 AES Input Configuration Menu

1. To terminate or unterminate all of the AES input pairs on the card

in this slot, press Terminate All. This is an alternate-action

button.

Configuration Selection

Main Screen

Audio

Processors

Audio Processor Card Menu

AES Input Card

Configuration

AES Input

Configuration Menu

Save / ExitHelp Cancel

1 2 3 4 5 6 7 8

AES

75-Ohm

Term

Terminate

All

AES Input Slot 4 Configuration Menu

Input Terminated

Input Not Terminated