User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
54
Chapter 3 The “How Do I...” Chapter
Frequently Asked Questions
Figure 3–24 Hardware Configuration Menu
1. Turn the
Clock Source knob to select the preferred clock and
press it. This control will always display the current sync source in
the lower rectangle. If the selected source and the current source
are different, this means the current source does not have a signal
applied.
Hardware Configuration Menu
Save / ExitHelp Cancel
Unit
Info
Factory
Default
-20dBFS = +4 dBu
Analog I/O
Ref Level
Current: Internal Sync
Clock
Source
Selected Slot 4 (AES In) Pair 1
8 hours
Screen
Saver
Screen
Bright
Balance
Control
Menu Lock
SuperPair
Balance
Left Right
16 32
Note:
Channels not locked to the current sync source will
mute automatically, or may periodically mute and
unmute if the sampling frequencies are closely related
but are drifting in and out of sync. You should choose a
source of sync that is stable, always present, and not
connected to an external switcher. A source of
composite black burst video connected to the genlock
input is the best choice.
In the unlikely event that only analog sources are
connected to the AMP2-16V, the Clock Source should
be set to
Internal.