User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
53
Chapter 3 The “How Do I...” Chapter
Frequently Asked Questions
Figure 3–23 Audio Processor Card Menu
1. Press the control associated with the slot that contains the card you
want to adjust (Figure 3–23 above). You may also configure the
optional Dolby decoder card.
2. Depending upon the type of card, there will be more or fewer
options that can be adjusted.
How Do I Set the Clock Source?
All inputs to the AMP2-16V must be synchronized to the same clock.
By default, the system will automatically select a logical clock source,
such as the 3G/HD/SD-SDI card in the lowest numbered slot.
However, you can also set the clock source to any AES input pair or to
the Reference Genlock Input.
This setup is done in the Hardware Configuration Menu:
Audio Processor Card Menu
ExitHelp Exit
3G SDI I/O Card
Configuration
Slot 1
No Card Installed
Analog I/O Card
Configuration
AES Output Card
Configuration
AES Input Card
Configuration
Slot 5
Slot 3
Slot 4
Dolby Card
Configuration
Dolby
Slot 2
Configuration Selection
Menu
Main Screen
Menu
Configure
Options
Option
Configuration Menu
Hardware
Configuration Menu
Configure
Hardware