User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
52
Chapter 3 The “How Do I...” Chapter
Frequently Asked Questions
Figure 3–22 Monitor Mixer Configuration Menu
1. Use the
Mixer Channel Select to scroll to the channel pair where
you want the output signals to be displayed.
2. Use the Source Pair Select control to select the output pair to be
metered.
3. Now is also a good time to use the Channel Function control to
designate the function of the channels in that pair.
4. Press the Set Clusters control to proceed to the Cluster
Configuration Screen
. On that screen, use the Select Cluster
control, following by the Edit Cluster Label control to name the
output meter pair.
How Do I Configure the Audio Inputs or Outputs?
If you need to initially set up the audio inputs so that they can be
monitored, refer to I. Configure the Monitor Mixer on page 5.
If you need to configure an input or output card in one of the slots, go
to the
Audio Processor Card Menu:
Monitor Mixer Configuration Menu
Save / ExitHelp Cancel
Chan 1 Chan 2 Chan 3 Chan 4
Slot 2 SDI-3G In
Pair 4
Slot 1 AES In
Pair 1
+0 +0 +0+0
Channel
Trim
Source
Pair
Select
Phase
LED
On/Off
Delay to Speakers = 170 mS
Audio
Delay
Dolby 5.1
Speaker
Mute:
Off
L Front R Front Center LFE
Channel
Func
Mixer
Channel
Select
Set
Clusters
Configuration Selection
Menu
Main Screen
Menu
Audio
Processors
Audio Processor Card Menu