User guide

821116: AMP2-16V Series User Guide

Chapter 3 The “How Do I...” Chapter

Frequently Asked Questions

1. Turn the control associated with the hot key you want the

downmix to be on so that the long bar (not the control label) is

highlighted. Press the control until the purple AES or Analog

Output Trim

function displays. If there are multiple output cards,

note that the card slot number is shown in parenthesis.

2. Turn the control to each of the 16 channels shown and press to

either include that channel in this control's adjustment or not.

Although you can set the control to adjust multiple channels, you

cannot set two different controls to adjust the same channel. If a

channel is already controlled by another hot key, its selection is

shown in gray.

How do I Show Mixer Output Levels on the Level

Meters?

If you have not done so already, you first need to set up a free mix in

the output card. Please refer toHow Do I Mix Any Input(s) to Any

Output(s)? on page 49 and set up the needed output mix.

To show mixer output levels, certain configurations must be avoided so

that potential internal feedback loops will not exist within the digital

mixer. Output levels cannot be displayed if:

1. The monitor mix output pair appears as one of the inputs to the

output mixer, or

2. The output mixer is in Follow Monitor mode.

3. Analog I/O Cards with the TOSLINK option will not allow the

analog outputs to be routed back to the monitor mixer to be

metered. The internal pathways used for this feature are also used

by the TOSLINK Card.

Output free mix channel pairs will appear as sources in the Monitor

Mixer Configuration Menu

Configuration Selection

Main Screen

Configure

Monitor Mixer

Configuration Menu