User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
47
Chapter 3 The “How Do I...” Chapter
Frequently Asked Questions
Figure 3–18 Monitor Mixer Configuration Menu
1. Rotate the Mixer Channel Select to select the 9th channel pair,
the SuperPair.
2. Rotate the Source Pair Select to select the audio processor card
slot and desired input pair on that card.
3. You may want to adjust the Channel Trim control to increase or
decrease the input gain to the level you need, relative to the other
channel audio levels. Turn the Mixer Channel Select knob to the
channel you want to adjust and then turn the Channel Trim knob
to adjust the level. If you will be using the Balance control as a
SuperPair Volume control, then set these trims to 0.
How Do I Set Up a SuperPair Volume Control?
A SuperPair is a 9th audio input pair that can be heard along with the
normally monitored audio channels. You can reconfigure the front
panel Balance control to become a SuperPair Volume control, that
will work independently of the main front panel Volume control. Like
the main Volume control, the SuperPair Volume control can be
pressed to dim or mute the SuperPair audio.
Monitor Mixer Configuration Menu
Save / ExitHelp Cancel
Chan 15 Chan 16 Super 1 Super 2
SuperPair
Slot 2 SDI-3G In
Pair 4
Slot 4 Toslink Input
+0 +0 +0+0
Channel
Trim
Source
Pair
Select
Phase
LED
On/Off
Delay Off
Audio
Delay
Pair 8
Speaker
Mute:
Off
L Front R Front L Front R Front
Channel
Func
Mixer
Channel
Select
Set
Clusters