User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
40
Chapter 3 The “How Do I...” Chapter
Frequently Asked Questions
Figure 3–11 Monitor Mixer Configuration Menu
4. Use the
Mixer Channel Select control to select the channel pair
that you want the first decoded Dolby pair to reside on.
5. Use the Source Pair Select control to select the decoded Dolby
pair, as shown below. Repeat steps 4 and 5 for each decoded pair.
6. Use the Channel Function control to designate the function of
the channels in that pair.
7. Press the Set Clusters control to cluster the decoded Dolby pairs
and then name the cluster.
How do I Display Dolby CRC Error Counts?
By default Dolby CRC error counts are flagged at the top of the right-
hand meter screen:
Monitor Mixer Configuration Menu
Save / ExitHelp Cancel
Chan 1 Chan 2 Chan 3 Chan 4
Dolby Decoder Pair 1 Dolby Decoder Pair 2
+0 +0 +0+0
Channel
Trim
Source
Pair
Select
Phase
LED
On/Off
Delay to Speakers = 170 mS
Audio
Delay
Dolby 5.1
Speaker
Mute:
Off
L Front R Front Center LFE
Channel
Func
Mixer
Channel
Select
Set
Clusters