User guide

821116: AMP2-16V Series User Guide

153

Chapter 6 Input/Output Modules and Options

Adding/Removing Modules

Removing an I/O Module

To remove a new 3G card, follow the instructions below.

1. Place the monitor on a solid, static-free surface and remove the

power cord(s).

2. Using a suitable socket wrench, adjustable wrench, or needle-nose

plyers, loosen the nuts on the gold BNC connectors and remove

them.

3. Using a small Phillips screwdriver, remove the top cover.

4. Unseat the card from the slot and remove the card (still connected

to the rear panel) through the rear panel opening.

5. Cover the rear panel opening with a blank rear panel cover.

6. Insert the rear panel cover screws and tighten.

7. Replace the lid and the screws.

CAUTION!

Static discharge can cause serious damage to sensitive semiconductor

devices. Avoid handling the circuit boards in high static environments

such as carpeted areas, and when synthetic or wool fiber clothing is

worn. Touch the frame to dissipate static charge before removing

boards from a frame, and always exercise proper grounding

precautions when handling circuit boards.

Note:

It may prove helpful to place the monitor with the rear panel

facing you for this procedure.

WARNING!

Do not attempt to operate the monitor without all rear panel cover

plates in place. Doing so will compromise the unit’s shielding.

Note:

All presets will be set to a factory default appropriate for the

new arrangement of cards.