User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
152
Chapter 6 Input/Output Modules and Options
Adding/Removing Modules
8. Insert the rear panel cover screws and tighten.
9. Replace the lid and the screws.
10. Tighten the external nuts on the gold BNC connectors.
Adding a Non-3G Card I/O Module
To add a new I/O module, follow the instructions below.
1. Place the monitor on a solid, static-free surface and remove the
power cord(s).
2. Using a small Phillips screwdriver, remove the top cover.
3. Remove the blank cover plate from the rear panel for the new I/O
module’s slot.
4. Remove the new I/O module from its shipping container being
careful to remain grounded.
5. Insert the new I/O module in the empty slot until the I/O module
snaps in securely.
6. Attach the rear panel connectors to the card and screw it to the rear
panel frame.
7. Replace the lid and the screws.
WARNING!
Do not attempt to operate the monitor without all rear panel cover
plates in place. Doing so will compromise the unit’s shielding.
Note:
It may prove helpful to place the monitor with the rear panel
facing you for this procedure.
Important:
Keep the blank cover plate for future use. We recommend taping it to
the side of the monitor; but do not cover the air vent.
WARNING!
Do not attempt to operate the monitor without all rear panel cover
plates in place. Doing so will compromise the unit’s shielding.