User guide

821116: AMP2-16V Series User Guide

151

Chapter 6 Input/Output Modules and Options

Adding/Removing Modules

Adding an I/O Module

Adding a 3G Option Card

To add a new 3G card, follow the instructions below.

1. Place the monitor on a solid, static-free surface and remove the

power cord(s).

2. Using a small Phillips screwdriver, remove the top cover.

3. Remove the blank cover plate from the rear panel for the new I/O

module’s slot. Remember to save the four screws for the new rear

panel cover plate.

4. Remove the 3G Option Card from its shipping container being

careful to remain grounded.

5. When you receive your 3G Option Card, it will arrive partially

assembled. Verify that the external nuts and washers on the gold

BNC connectors are loose.

6. Insert the 3G Option card into the rear panel opening being careful

not to snag the ribbon cables. Keep them folded against the circuit

board to keep them out of the way.

7. Insert the card into the slot and press firmly until it plugs in

securely.

Decision Point:

If you would like to add a 3G Card, then continue on to Adding a 3G

Option Card immediately below.

Otherwise, if you would like to add a different type of I/O module,

continue on to Adding a Non-3G Card I/O Module on page 152.

Note:

It may prove helpful to place the monitor with the rear panel

facing you for this procedure.

Important:

Keep the blank cover plate for future use. We recommend taping it to

the side of the monitor; but do not cover the air vent.