User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
150
Chapter 6 Input/Output Modules and Options
Adding/Removing Modules
17. Replace the washers and nuts on the REF connectors.
18. Screw in the rear panel from the bottom of the monitor.
19. Replace the lid and the screws.
Removing a Dolby D/E Card
To remove a Dolby D/E Card, follow the instructions in reverse for
Adding a Dolby D/E Card on page 143 and leave the standoffs
attached to the system control board.
Note:
All presets will be set to a factory default appropriate for the
new arrangement of cards.