User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
148
Chapter 6 Input/Output Modules and Options
Adding/Removing Modules
Figure 6–15 Tighten First Standoff Screw
12. Adjust (if needed) and tighten the first standoff screw on the
opposite side of the system control board, and then attach another
screw on top of the standoff as shown in Figure 6–15 above.
Figure 6–16 Tighten Second Standoff Screw
13. Similarly, adjust and tighten the second standoff screw on the
opposite side of the system control board, and then attach another
screw on top of the standoff as shown in Figure 6–16 above.