User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
144
Chapter 6 Input/Output Modules and Options
Adding/Removing Modules
1. Place the monitor on a solid, static-free surface and remove the
power cord(s).
2. Using a small Phillips screwdriver, remove the top cover.
Figure 6–7 Remove Bottom Screw
3. Pull the monitor so that it slightly hangs over the edge of the
surface on which it is sitting, and remove the screw on the bottom
as shown in Figure 6–7 above.
Figure 6–8 Remove Nuts and Washers
4. Using the wrench, remove the nuts and washers from the REF
connectors as shown in Figure 6–8 above.