User guide

821116: AMP2-16V Series User Guide

142

Chapter 6 Input/Output Modules and Options

Adding/Removing Modules

Requirements

• A small Phillips screwdriver

• The redundant power supply option kit (See Option Kits on page

154 for more information.)

Adding the Power Supply

To install an additional power supply, follow the instructions below.

1. Remove the power cord.

2. Using a small Phillips screwdriver, the blank cover plate on the

rear panel on the far right-hand side.

3. Slide the power supply into the slot from the rear panel, making

sure that the power supply’s connector seats securely into the

connector inside the monitor.

4. Screw in the two captive thumbscrews that hold the power supply

in place.

5. Attach the power cords to the power supply connectors and plug

them into an outlets protected by different breakers.

Adding/Removing Modules

Wohler’s standard models typically do not populate all five slots,

allowing for the addition of other modules. This section describes the

procedures for adding new cards and removing existing cards.

Note:

It may prove helpful to place the monitor with the rear panel

facing you for this procedure.

Important:

Keep the blank cover plate for future use. We recommend taping it to

the side of the monitor; but do not cover the air vent.

Important:

It is crucial that the secondary power supply be plugged into an outlet

on a different circuit breaker than the original power supply to ensure

system redundancy.