User guide

821116: AMP2-16V Series User Guide

141

Chapter 6 Input/Output Modules and Options

Dolby D/E Card

Connector Pin-Outs

Since the pin-outs fo the Analog I/O and SPDIF TOSLINK Card are

identical to those of the Analog I/O Card, refer to Connector Pin-Outs

on page 141.

Dolby D/E Card

Installing a Dolby D/E Card activates the Dolby Configuration and

Metadata Display Menu

and allows hot keys to be assigned to the

Dolby Zoom function

Adding a Redundant Power Supply

The AMP2-16V Series monitors come with a single 150W power supply

that is sufficient to drive a fully-loaded monitor. However, an

additional power supply (also 150W) is available as an option to

provide for system redundancy. Power supply modules are to be

installed into their specialized slots on the far left and far right of the

back panel. When adding an optional redundant power supply,

remove the blank cover to gain access to the power supply slot.

Precautions

Before unpacking your new power supply, make sure you have a static-

free surface on which to work.

Note:

Analog I/O cards with TOSLINK options will not allow the

analog outputs to be routed back to the monitor mixer. The

internal pathways used for this feature are also used by the

TOSLINK card.

Note:

The Dolby D/E Card does not have a rear panel adaptor.