User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
137
Chapter 6 Input/Output Modules and Options
Analog I/O Card
Figure 6–5 Analog I/O Card Rear Panel Adaptor
and Rear Card Cover Plate
Menu Modifications
You can select the analog input from the Monitor Mixer
Configuration Menu
and also from the AES and Analog Output
Menus
.
The Audio Processor Configuration Menu will now display an
Analog I/O knob. Pressing this knob will display the Analog Output
Configuration Menu
from which you can select and configure the
outputs.
Connector Pin Outs
The pin out of the balanced analog input connector is listed in Table 6–5
below.
Note:
You can modify the analog reference levels in the
Hardware Configuration Menu.
Note:
The balanced analog input connector pin out is the same as
the commercially-available Tascam DA-88 adapter cables.