User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
127
Chapter 5 Menu List
Unit Information Menu
Figure 5–33 Unit Information Menu - (Application)
• Unit Name: Pressing this knob proceeds to the Label Menu where
you can name this particular AMP2-16V so that this name can be
seen remotely when updating software via the Ethernet.
• Unit S/W Info.: Pressing this knob displays the version of each
software component in the unit and the I/O modules that this unit
contains.
• Ethernet Serial Info: Pressing this knob changes this menu to show
the Ethernet and serial port information as shown in Figure 5–34
below.
Figure 5–34 Unit Information Menu - (Ethernet)
• S/W Update: Do not use this knob unless instructed to do so by
Wohler technical support.
Unit Information Menu
Exit
Application: AMP2-16-V
Application Version: 4.16
NvRam Table Version: 00.64
Graphics Software Version: 02.53
Motherboard FPGA Version: 02.26
Motherboard DSP Version: 02.02
Front Panel Code: 848093 V. 1.3.0
Processor Slot Contents
PS 1: 3G IO Embed Board V03.02
PS 2: Empty
PS 3: Empty
PS 4: Empty
PS 5: Empty
Unit S/W
Info.
Ethernet
Serial
Info.
S/W
Update
Dolby Version: 2.1.2.6
Motherboard CPLD Version: 03.04
Unit Information Menu
Exit
Ethernet Port Configuration
IP Address: 0.0.0.0
MAC Address: 00:03:f4:02:97:55
Serial (RS-232) Port Configuration
Baud Rate: 115200
Parity: None
Data Bits: 8
Stop Bits: 1
Handshaking: None
Unit S/W
Info.
Ethernet
Serial
Info.
S/W
Update
Network Mask: 0.0.0.0
Gateway: 0.0.0.0
DNS: 0.0.0.0
Unit Name: Edit Studio Mon 3
Ethernet
Setup