User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
103
Chapter 5 Menu List
Hardware Configuration Menu
Figure 5–16 Hardware Configuration Menu
• Clock Source: Rotating this knob selects the input source for audio
clocking. You can use the Ref input on the rear panel to provide a
Genlock sync signal to which all sources are locked. To use this
connector, set this control to Ref Genlocked. If there is only one
input card and no Ref input, this is automatically set to that card. If
the currently-selected source is unlocked, the system will
automatically choose another locked source. When this happens,
the current source and the selected source fields will be different.
Clock problems are displayed in red on the Main Screen as shown
in Figure 5–17 below.
Figure 5–17 Genlock Lost Indicator on Main Screen
• Screen Saver: Rotate this knob to select the interval of time the
system will wait from the time the user last touched any of the front
panel controls, to the time that the system will display the screen
saver across both screens. Values can be Off (no screen saver
display) or from 5 Mins to 24 Hrs. Setting a time will prolong the
life of the front panel screens.
• Analog I/O Reference Level: Rotating this knob allows you to
select from any of the following eight analog I/O reference levels:
Hardware Configuration Menu
Save / ExitHelp Cancel
Unit
Info
Factory
Default
-20dBFS = +4 dBu
Analog I/O
Ref Level
Current: Internal Sync
Clock
Source
Selected Slot 4 (AES In) Pair 1
8 hours
Screen
Saver
Screen
Bright
Balance
Control
Menu Lock
SuperPair
Balance
Left Right
16 32
Note:
You must set the Clock Source for each chosen preset.
All other settings on this page affect all presets.
+0
Anlg
1
Dolby
5.1
0
-10 -10
0
D
o
D
o
A
E
A
E
A
n
A
n
GENLOCK LOST
Genlock Lost
Indicator