Installation Guide

9
PROBRITE.COM
Please call 1-844-507-5651 or email support@probrite.com for further assistance.
8
Visit www.probrite.com/install for installation video tutorials and product support
Installation (continued)
3B
Remove the glass
globe and heat sink
from junction box
BB
A
C
4B
Installing the external junction box
Installation (continued)
(fig 1).
(fig 2b).
(fig 2a).
(fig 1).
(fig 2).
CC
B
B
Surface Conduit Mount
Mark and drill two holes on the wall
surface as per the desired location for
fixing the cast junction box (B).
Place the junction box gasket (CC)
between the cast junction box (B) and
the wall surface. (Fig. 2)
Use suitable screws applicable to
the mounting surface and secure the
junction box (B) on the surface. (Fig. 2)
Remove the wire guard (C) from the
heat sink (D) by loosening the locking
screw using the allen key (BB). (Fig. 1)
Remove the globe (A) from the heat
sink (D) by unscrewing it. (Fig. 1)
Remove the reflector from the heat sink
(D) by loosening two small screws on
top (Fig 2a).
Remove the black rubber gasket.
Remove the heat sink (D) from the wall
mounting arm (E) by removing the two
philips head screws on each side of the
heat sink as shown in Fig. 2b.
Also remove the wall mounting arm
(E) from the cast junction box (B) by
removing the four screws using a philips
screwdriver. (Fig. 3)
D
B
(fig 3).
E
CAUTION: DO NOT touch the LED and DO
NOT damage or soil the reflector inside the
heat sink.
Reflector
Gasket
Follow Instructions Below for Side-Entry Conduit Surface Mounting
NOTE: To remove the junction box (A) ,first
remove the black rubber gasket inside the
heat sink and then unscrew the two screws
underneath
Screws
(Provided by
others)
Screws
(Provided by others)