Installation Guide

11
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
10
Visit www.probrite.com/install for installation video tutorials and product support
Installation (continued)
Installation (continued)
6
Reassembling the
fixture
7
Caulking around the
light fixture
B
NOTICE: Failure to properly caulk around the
surface and cast junction box (B) could lead
to water damage and is not covered under
warranty.
☐ Fix the heat sink (D) to the cast
junction box (B) using by tightening
the two philips head screws
removed earlier, using the philips
screwdriver (Fig. 1a ).
☐ Replace the black gasket and then
fix the reflector back on the heat
sink (D) using two small screws
removed earlier. (Fig. 1b).
☐ Replace the protection glob (A) on
the hear sink (D) by threading it
back. (Fig. 2)
☐ Thread the wire guard (C) over the
glass globe (A) and tighten the wire
guard with the locking screw using
the allen key (CC). (Fig. 2)
☐ Caulk around the cast junction box (B)
and surface with silicone sealant (not
included).
☐ If applicable, caulk around any conduit
pipes and conduit entry holes to make
a water-tight seal.
Side Conduit Mount
Care and Cleaning
☐ Shut o main power supply before cleaning the product. To prolong the original ap-
pearance, clean the light fixture with clear water and a soft, damp cloth only.
☐ Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints,
solvents, or any other chemicals on this light fixture. They could cause a premature
deterioration of the finish and may void the warranty.
☐ Do not spray the light fixture with a hose or power washer.
CC
B
D
A
C
(fig 2).
If Light does not come on:
☐ Verify that the power is turned ON from the circuit breaker and wall switch.
☐ Verify the wiring for the fixture is done properly.
☐ Verify the line voltage is correct.
If Light flickers:
☐ Do not wire to a dimming switch, use a standard ON/OFF switch
Troubleshooting
(fig 1b).
(fig 1a).
Reflector
Gasket