Installation Guide

9
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
8
Visit www.probrite.com/install for installation video tutorials and product support
Conduit
Installation (continued)
3C
Remove the glass
globe and heat sink
4
Installing the cast junction box
Installation (continued)
5
Making the electrical
connections
AA
B
(fig 1).
(fig 1).
(fig 2).
CC
B
B
Side Conduit Mount
Side Conduit Mount
☐ Remove one conduit plug from the
side of the cast junction box (B) from
the where conduit will enter (Fig. 1).
☐ Pull the wires from the conduit entry
and attach the conduit to the hole of
the junction box (B).
☐ Make wiring connections inside the
cast junction box (B) as per the
instructions given below.
☐ Take conduit plug removed from the
side and place on the top hole of the
junction box (B) to close holes.
☐ Place silicone sealant around conduit
and entry to make for a water-tight
seal.
☐ Mark and drill two holes on the ceiling
surface as per the desired location for
fixing the cast junction box (B).
☐ Place the junction box gasket (CC)
between the cast junction box (B) and
the ceiling surface. (Fig. 2)
☐ Use two suitable screws (provided by
others) applicable to the mounting
surface and fix the cast junction box
(B) on the surface. (Fig. 2)
Conduit mounting
☐ Remove the wire guard (C) from the
heat sink (D) by loosening the locking
screw using the allen key (CC). (Fig. 1)
☐ Remove the globe (A) from the heat
sink (D) by unthreading it. (Fig. 1)
☐ Remove the reflector from the heat
sink (D) by loosening two small screws
on top and then also remove the black
gasket.(Fig 2a)
☐ Remove the heat sink (D) from the
junction box (B) by removing the two
philips head screws as shown in Fig.
2b.
D
CC
B
D
A
C
(fig 1).
(fig 2b).
(fig 2a).
Reflector
Gasket
CAUTION: DO NOT touch the LED and DO
NOT damage or soil the reflector inside the
heat sink.
Follow Instructions Below for Side-Entry Conduit Mounting
NOTE: To remove the junction box (A) ,first
remove the black rubber gasket inside the
heat sink and then unscrew the two screws
underneath
Wiring instructions
☐ If necessary, strip 3/8" of insulation
from junction box or fixture (A) wires
(fig 1).
☐ Connect fixture black wire to house
black wire, the (+) line, and fixture
white wire to house white wire, the (-)
common by twisting the exposed wires
together and using the wire nuts (AA).
Ensure no loose wires.
☐ Connect house ground wire to the
green fixture ground wire, by twisting
the exposed wires together and using
the wire nuts (AA).
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
GROUND
BLACK
WHITE
GREEN
(fig 1).
TIP: Hold stripped ends near each other and
align any frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your
fingers to twist the wire nut clockwise until tight.
Check for tightness by pulling wires.
Screws
(Provided by others)
Screws
(Provided by others)